Norland Optical Adhesive 133

 

  Norland Optical Adhesive 133 is clear liquid adhesive that will cure when exposed long wavelength ultraviolet light. NOA 133 is recommended for bonding for glass to glass. Adhesion is also good to cellulose acetate  

  butyrate.  NOA 133 is cured by ultraviolet light between 320 to 450 nm. Full cure requires 6 Joules/cm 2 . The adhesive exhibits oxygen inhibition when used as a coating.  To overcome this the adhesive must be cured

  under an inert atmosphere, such as nitrogen.  When used as a coating the liquid adhesive's temperature must be kept below 9C to prevent vaporization.

 

 

Typical Properties of NOA 133

 

 

Refractive Index

1.33

Temperature Range

-15°C to 90°C

Viscosity @ 25C

 15 cps

                                                                  

 

  Keep NOA 133 in a coo l(5-20°C) dark place. If refrigerated, allow the adhesive to come to room temperature before using.

 

  Care should be taken in handling the this material. The material Safety Data Sheet should be read for this product. Prolonged contact with skin should be avoided and affected areas should be washed thoroughly with

  copious amounts of soap and water. If adhesive gets into eyes, flush with water for 15 minutes and seek medical attention.

 

 

Spectral Transmission of NOA 133

[Click Here To View MSDS Information]

Home - Adhesives - Fiber Optics - Fish Gel - Distributors - About - Trade Shows - Employment -