PRODUCT USE: Gelatin for Photoengraving Industry
CAS NUMBER: 9000-70-8
| COMPONENTS | CAS# | OSHA PEL | ACGIH TLV | Other Limits Recommended |
| Phenol | 108-95-2 | 5ppm | 5ppm | 19mg/m(3) |
NA = Not Applicable NAv = Not Available NE = Not Established
|
|
|
|
|
|
|
|
|
|
|
(Contains <1%) |
III. PHYSICAL DATA
BOILING POINT (°C): NA
SPECIFIC GRAVITY (H20=1): 1.17
VAPOR PRESSURE (mm Hg): NA
PHYSICAL STATE: Liquid
VAPOR DENSITY (AIR=1): NA
EVAPORATION RATE: NA
ODOR THRESHOLD (ppm): NA
FREEZING POINT (°C): NA
APPEARANCE AND ODOR: Mild odor, transparent tan liquid
FLASH POINT: NA
FLAMMABILITY: None
EXTINGUISHING MEDIA: Carbon dioxide, foam, dry chemical.
UPPER FLAMMABLE LIMIT (% By Volume): NA
LOWER FLAMMABLE LIMIT (% By Volume): NA
AUTO IGNITION TEMPERATURE (°C): NA
HAZARDOUS COMBUSTION PRODUCTS: None
EXPLOSION DATA: Sensitivity to Impact: None.
Sensitivity to Static Discharge: None
CHEMICAL STABILITY: Stable
CONDITIONS TO AVOID: None
HAZARDOUS DECOMPOSITION PRODUCTS:
None.
ROUTES OF ENTRY: Ingestion, Inhalation, Skin Contact
EFFECTS OF EXPOSURE: Phenol is poisonous and should not be ingested.
CHRONIC: None
EXPOSURE LIMITS: Lethal oral doses 1-10 gms for adults, 50-500 mg for infants.
CARCINOGENICITY: No
TERATOGENICITY: No
REPRODUCTIVE TOXICITY: No
MUTAGENICITY: Yes
SPECIFIC MEASURES:
EYE CONTACT: If the material gets in the eyes, immediately wash eyes with copious amounts of water, occasionally lifting the lower and upper eyelids. Continue for 15 minutes. Seek medical attention. Use same procedure if contact is with a solution of gelatin and water.
SKIN CONTACT: Wash with soap and water, remove contaminated clothing.. INGESTION: Induce vomiting and seek immediate medical attenton.
INHALATION: Remove to fresh air
PERSONAL PROTECTIVE EQUIPMENT:
GLOVES: None
RESPIRATOR: May be needed under certain conditions where significant exposure to dust may occur.
EYE: Safety glasses.
OTHER PROTECTIVE CLOTHING: Follow normal safe work practices when dealing with chemicals.
ENGINEERING CONTROLS: Use local and mechanical exhaust to minimize exposure to dust.
LEAK AND SPILL PROCEDURE: Flush with water, for large spills collect liquid with absorbent material and package for disposal according to local, state and federal regulations.
WASTE DISPOSAL: Material is biodegradable. Dispose of in an appropriate manner.
STORAGE REQUIREMENTS: Store at room temperature or below.
SPECIAL SHIPPING INFORMATION: UN NUMBER - Not regulated.
TELEPHONE: 609-395-1966
EMERGENCY TELEPHONE: 609-395-1966
DATE: November 1, 2007
SUPERSEDES: December 28, 2005
The data included herein are presented according to Norland Products' practices current at the time of preparation hereof, are made available solely for the consideration, investigation and verification of the original recipients hereof and do not constitute a representation or warranty for which Norland Products assumes responsibility. It is the responsibility of a recipient of this data to remain currently informed on chemical hazard information, to design, and update its own safety program and to comply with all national, federal, state and local laws and regulations applicable to safety, occupational health, right to know and environmental protection.
All components of this product are in compliance with the Toxic Substances Control Act (TSCA) inventory.