For information or emergency: Telephone 609-395-1966
Date prepared January 1, 2013
I. PRODUCT INFORMATION
MANUFACTURER:
Norland Products Inc.
TRADE NAME: Norland Index Matching Liquid
150
SYNONYMS: IML 150
CHEMICAL NAME: Triallyl Trimellitate
HEALTH
1
FLAMMABILITY
1
REACTIVITY
1
PROTECTIVE
B
Hazard Rating
4 - Extreme
3 - Serious
2 - Moderate
1 - Slight
0 - Minimal
B - Gloves & Eye Protection
II. HAZARDOUS COMPONENTS
COMPONENTS
CAS#
CONCENTRATION
OSHA PEL
ACGIH TLV
LD50
LC50
Triallyl Trimellitate
2694-54-4
>90%
2 ppm
NE
NE
0.01
NA = Not Applicable NE = Not Established ND
= Not Determined
All chemicals used for manufacturing this
product are included on the TSCA list of chemical substances.
III. PHYSICAL DATA
BOILING POINT: 160°C/320°F
SPECIFIC GRAVITY (H20=1): 1.16
VAPOR PRESSURE: NA
MELTING POINT: Liquid at room temperature.
VAPOR DENSITY (AIR=1): >1
EVAPORATION RATE (BA=1): <1
SOLUBILITY IN WATER: Insoluble
PERCENT VOLATILE BY VOLUME: <.1
ODOR AND APPEARANCE: Pale yellow liquid, mild
odor.
IV. FIRE AND EXPLOSION DATA
FLASH POINT: 203°F open cup
EXTINGUISHING MEDIA: Carbon Dioxide, foam
or dry chemical.
SPECIAL FIRE FIGHTING PROCEDURES: None
UPPER FLAMMABLE LIMIT (% By Volume): ND
LOWER FLAMMABLE LIMIT (% By Volume): ND
AUTO IGNITION TEMPERATURE (°C): NA
UNUSUAL FIRE AND EXPLOSION HAZARDS: Fumes
of allylic compounds may be produced.
V. REACTIVITY DATA
CHEMICAL STABILITY: Product is sable. Avoid
temperatures above 105°F/65°C. Oxidizers or actinic radiation may
cause non-hazardous polymerization.
HAZARDOUS DECOMPOSITION PRODUCTS: None
HAZARDOUS POLYMERIZATION: Will not occur.
VI. HEALTH HAZARD DATA
ROUTES OF ENTRY: Inhalation, skin or ingestion.
EFFECTS OF EXPOSURE:
ACUTE: May cause dermatitis, shortness of
breath, fainting, headaches and nausea.
CHRONIC: Repeated contact may cause sensitization
in some individuals.
EXPOSURE LIMITS: None established for mixture.
LD50 (Mixture): No data for mixture
LC50 (Mixture): No data for mixture
CARCINOGENICITY: None
TERATOGENICITY: No
REPRODUCTIVE TOXICITY: No
MUTAGENICITY: No
SIGNS AND SYMPTOMS OF EXPOSURE: Skin rash
in area of contact.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY
EXPOSURE: Skin allergies, asthma bronchitis, emphysema and other respiratory
disorders.
EMERGENCY AND FIRST AID PROCEDURES: If contact
on skin, immediately wash area with soap and water. If implanted in eyes,
immediately wash the eyes with copious amounts of water. Occasionally lifting
lower and upper eyelids. Continue for 15 minutes. Get medical attention If
swallowed, dilute with milk or water. Get medical attention.
VII. PRECAUTIONS FOR SAFE HANDLING AND
USE
STEPS TO BE TAKEN IN CASE MATERIAL IS SPILLED:
Wipe up with absorbent material and rinse with non-polar solvent.
WASTE DISPOSAL METHOD: Incinerate in accordance
with Federal, State and Local regulations.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING:
This material should not be ingested or taken internally. Spraying as aerosol
or mist not recommended. If this is done, protection must be taken against
inhalation.
VIII. CONTROL MEASURES
PERSONAL PROTECTIVE EQUIPMENT:
GLOVES: Nitrile or butyl rubber.
RESPIRATOR: Not required under normal operating
conditions.
EYE: Safety glasses.
VENTILATION REQUIREMENTS: Use local or mechanical
exhaust.
WORK HYGIENIC PRACTICES: If clothing gets
contaminated, wash before rewearing. Practice good housekeeping and vigorous
personal hygiene to minimize contact with material
IX.
TRANSPORTATION
TRANSPORT
INFORMATION: N/P
X. PREPARATION DATE OF MSDS
PREPARED BY: Material Safety Department
TELEPHONE: 609-395-1966
EMERGENCY TELEPHONE: 609-395-1966
DATE: January 1, 2013
SUPERSEDES: June 1, 2010
The data included herein are presented according
to Norland Products' practices current at the time of preparation hereof,
are made available solely for the consideration, investigation and verification
of the original recipients hereof and do not constitute a representation or
warranty for which Norland Products assumes responsibility. It is the responsibility
of a recipient of this data to remain currently informed on chemical hazard
information, to design, and update its own safety program and to comply with
all national, federal, state and local laws and regulations applicable to
safety, occupational health, right to know and environmental protection.
All components of this product are in compliance
with the Toxic Substances Control Act (TSCA) inventory.