TRADE NAME: Norland Optical Adhesive 144
SYNONYMS: NOA 144
PRODUCT USE: Ultraviolet Cure Adhesive
HEALTH |
2 |
FLAMMABILITY |
3 |
REACTIVITY |
2 |
PROTECTIVE |
B |
Hazard Rating
4 - Extreme 3 - Serious 2 - Moderate 1 - Slight 0 - Minimal B - Gloves & Eye Protection |
II. HAZARDOUS COMPONENTS
COMPONENTS |
CAS# |
CONCENTRATION |
OSHA PEL |
ACGIH TLV |
LD50 |
LC50 |
Aliphatic Urethane Acrylate* |
* |
5-20% |
NE |
NE |
NAv |
NAv |
Acrylate Monomer |
* |
40%-85% |
NE |
NE |
NAv |
NAv |
NA = Not Applicable NAv = Not Available NE = Not Established
* The specific chemical identity and concentration is being withheld from this data sheet as a Trade Secret.
III. PHYSICAL DATA
BOILING POINT (°C): NA
SPECIFIC GRAVITY (H20=1): NAv
VAPOR PRESSURE (mm Hg): NAv
PHYSICAL STATE : Liquid
VAPOR DENSITY (AIR=1): NAv
EVAPORATION RATE: NAv
pH: NA
PERCENT VOLATILE BY VOLUME: <.1
ODOR THRESHOLD (ppm): NAv
FREEZING POINT (°C): NAv
ODOR AND APPEARANCE: Strong Acrylic odor. Clear
SOLUBILITY IN WATER: Not soluble COEFFICIENT OF WATER/OIL DISTRIBUTION: NAv
IV. FIRE AND EXPLOSION DATA
FLASH POINT: NAv
FLAMMABILITY: Yes
EXTINGUISHING MEDIA: Carbon Dioxide, foam, dry chemical.
UPPER FLAMMABLE LIMIT (% By Volume): NA
LOWER FLAMMABLE LIMIT (% By Volume): NA
AUTO IGNITION TEMPERATURE (°C): NA
HAZARDOUS COMBUSTION PRODUCTS: Could generate carbon monoxide, carbon dioxide or nitrogen oxide.
EXPLOSION DATA:
Sensitivity to Impact: None
Sensitivity to Static Discharge: None
V. REACTIVITY DATA
CHEMICAL STABILITY: Stable
INCOMPATIBILITY WITH OTHER SUBSTANCES: Exposure to U.V. , sunlight or temperatures above 45° C may cause a nonhazardous polymerization reaction.
HAZARDOUS DECOMPOSITION PRODUCTS: None
VI. HEALTH HAZARD DATA
ROUTES OF ENTRY: Inhalation or skin.
EFFECTS OF EXPOSURE:
ACUTE: Eye contact will cause irritation. May cause dermatitis, shortness of breath, fainting, headaches and nausea.
CHRONIC: Repeated or prolonged skin contact may cause sensitization.
EXPOSURE LIMITS: None established for mixture.
LD50 (Mixture): No data for mixture
LC50 (Mixture): No data for mixture
CARCINOGENICITY: NE
TERATOGENICITY: NE
REPRODUCTIVE TOXICITY: NE
MUTAGENICITY: NE
IRRITANCY OF PRODUCTS: Moderate eye and skin irritant. Inhalation of vapors or mists may cause irritation of the respiratory tract.
SENSITIZATION TO PRODUCT: Can cause an allergic reaction.
SYNERGISTIC PRODUCTS: The use of certain alcohols in conjunction with this product can increase the risk of skin irritation and/or sensitization as they remove the protective oils on the skin.
VII. FIRST AID MEASURES
SPECIFIC MEASURES:
EYE CONTACT: If the material gets in the eyes, immediately wash the eyes with copious amounts of water, occasionally lifting the lower and upper eyelids. Continue for 15 minutes. Get medical attention immediately.
SKIN CONTACT: If the material gets on the skin, immediately wash the area with soap and water and flush with water. If the material gets on clothing, remove the clothing and wash the affected area with soap and water. If irritation develops, get medical attention. Discard or wash contaminated clothing before reuse.
INGESTION: If the material has been swallowed, dilute with milk or water if the victim is alert. See doctor as soon as possible.
INHALATION: If overcome by vapors or fumes, remove to fresh air. Get medical attention if symptoms persist.
VIII. PRECAUTIONS FOR SAFE HANDLING AND USE
PERSONAL PROTECTIVE EQUIPMENT:
GLOVES: Nitrile or butyl rubber.
RESPIRATOR: Not required under normal operating conditions. Respiratory protection may be needed under certain conditions where significant exposure to fumes or mists may occur. An air purifying respirator equipped with organic vapor cartridges is recommended. Selection and use must comply with any existing federal standards for respiratory protection.
EYE: Safety glasses.
FOOTWEAR: Leather shoes.
CLOTHING: Cover arms and legs.
OTHER: NA
ENGINEERING CONTROLS: Use local and mechanical exhaust to minimize exposure to vapors or mists.
LEAK AND SPILL PROCEDURE: Contain material with absorbents. Place in container for disposal. Clean up with soap and water and flush area with water.
WASTE DISPOSAL: Material may be cured solid by exposure to u.v light. Cured material may be disposed of in landfill. Comply with all regulations.
HANDLING PROCEDURES AND EQUIPMENT: Do not reuse container. This product is for industrial use only. Practice good housekeeping and vigorous personal hygiene to minimize contact with material.
STORAGE REQUIREMENTS: Store at 5-25°C. Keep away from sunlight.
SPECIAL SHIPPING INFORMATION: UN NUMBER - Not regulated.
IX. PREPARATION DATE OF MSDS
PREPARED BY: Material Safety Department
TELEPHONE: 609-395-1966
EMERGENCY TELEPHONE: 609-395-1966
DATE: May 1, 2011
The data included herein are presented according to Norland Products' practices current at the time of preparation hereof, are made available solely for the consideration, investigation and verification of the original recipients hereof and do not constitute a representation or warranty for which Norland Products assumes responsibility. It is the responsibility of a recipient of this data to remain currently informed on chemical hazard information, to design, and update its own safety program and to comply with all national, federal, state and local laws and regulations applicable to safety, occupational health, right to know and environmental protection.